On my Kamaka the edges of the fret wires are noticeable when I slide my hand along the edge of the neck. Is there a way I can smooth them out? Small file? Thanks
I'm assuming your fret wire edges are the problem?
If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.
I'm assuming your fret wire edges are the problem?
If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.