Timbuck
Well-known member
I put a concert body together today..I must have got something wrong some where when putting the back on cos the seam at the lower bout didnt close up as tight as it should have and there was 1/2 mm gap
So I decided that the bindings will get that (I hadnt planned on bindings on this one but what the heck)..so I sorted out some black linings but they were about 1mm too wide ...I should have sanded them down, but I was in a lazy mood and i thought to myself "I'll scrape them down on the uke afterwards" ..I finally got them flush with sides but bit took nearly an hour to scrape and sand them..It turned out ok in the end, But! with a bit of care and attention to what I was doing I could have saved myself a lot of work and frustration :wallbash:
Tomorrow I'll give myself a good talking to, and try and do better.
So I decided that the bindings will get that (I hadnt planned on bindings on this one but what the heck)..so I sorted out some black linings but they were about 1mm too wide ...I should have sanded them down, but I was in a lazy mood and i thought to myself "I'll scrape them down on the uke afterwards" ..I finally got them flush with sides but bit took nearly an hour to scrape and sand them..It turned out ok in the end, But! with a bit of care and attention to what I was doing I could have saved myself a lot of work and frustration :wallbash:
Tomorrow I'll give myself a good talking to, and try and do better.