PDA

View Full Version : What to do if some notes are muted when I try to play them?



AlexEllwood
12-21-2016, 01:33 AM
Sometimes some notes are muted when I play them. My fingers are all in the right place, and they're all touching the strings (not even pressing down).
My sister plays the guitar and she tried to help, but she couldn't.
I'm unsure what I'm doing wrong, please help.

Croaky Keith
12-21-2016, 01:38 AM
You have to fret with the tip of your finger, if you are just starting out, it is very common to mute a string next to the one you are fretting.

Building up/hardening your finger tip skin & practice will solve it. :)

Dan Gleibitz
12-21-2016, 01:59 AM
My fingers are all in the right place, and they're all touching the strings (not even pressing down).

Try pressing down. You need enough pressure to make sure the string is firmly pressed against the fret in front of your finger (but not so much you bend the note out of tune). Also make sure your other fingers aren't touching the string accidentally or that will mute it.

DownUpDave
12-21-2016, 02:21 AM
It can be a number of things. As others have said make sure your other fingers are not touching any strings. Make sure you fretting finger has ONLY touched the intended string. Touching the string above or below will mute them. Make sure you are pressing down JUST behind the fret wire, if your finger is on top of the fret wire it will deaden the sound. One last thing......and I am quilty of this is forgetting to roll up my sleeve on my strumming arm and having it lay on the strings which deaden the notes. Make sure your strumming hand is not brushing the strings.:-)This is how we purposely "palm mute" or chunk a strum.

DownUpDave
12-21-2016, 03:05 AM
What type of uke is it....make model and size. Do you know what type of strings are on it. I am going to be blunt here but some cheap ukes especially sopranos with no name strings have a lot of dull dead notes and can sound like crap all over the fret board.

Choirguy
12-21-2016, 03:05 AM
If you are just starting to play, having some arch in the fingers (unless you are barre-ing a chord) is essential, as well as having the thumb somewhere on the neck where you provide support against your fingers.

I have my students start off by making an "OK" sign, and moving the ukulele in-between the fingers.

As the others have said, make sure you are behind the fret (ideally as close to the fret without being on top of it), and make sure your fingers are pressed down hard enough that the strings are vibrating only between the fret and the saddle.

All that said, I have heard plenty of very good players unintentionally mute a string here and there.

What chords are you trying to play?

Mivo
12-21-2016, 06:29 AM
Also make sure your sleeves aren't touching the strings close to the bridge.

SailingUke
12-21-2016, 07:38 AM
Bad strings and/or a poorly setup uke, can also be contributing factors.

Nickie
12-21-2016, 12:52 PM
I have the same problem with Bb on my favorite uke. I just strum that chord harder, and it works.

Tootler
12-22-2016, 05:38 AM
If you're just starting out, it's very easy to misplace or not press on the string correctly. You need to curl you finger over and press with the tip. The Bb problem Nickie mentioned is one I had and still have as you are pressing two strings with one finger and you need to ensure your fingers are placed so they press both strings evenly.

Half the secret is to take your time fingering the chord until you can do it reliably before trying to speed up to the desired tempo. (Advice I regularly fail to take I'm afraid)

I problem I found when starting out was I was worried I couldn't get to the next chord on time so I was always trying to rush the chord changes. Once I realised that I actually had more time than I had realised, I started to relax and my chord changes improved and became much cleaner.