Timbuck
Well-known member
I was making some fretboards this morning ..I have this special jig that I made for routing the fancy pointy bit at the end of the fret board...I did a couple which tuned out pretty good...then I got an idea "Why don't I fit two at a time in the jig and speed up the job"???...so I gave it a go they fitted nicely on top of each other, I clamped them in place and started up the router table..gently fed them in then !!! BANG the cutter dug in and split both rosewood boards down the centre and now I need fresh underwear ..I'll not do that again.
Last edited: