PDA

View Full Version : Uke action



beebssverige
07-10-2017, 08:52 AM
Such a newbie here. I just bought a used Greg Bennett concert and the 2,3 and 4 string action seems great but the 1 string buzzes and it may be that the action is too low. Is it possible to have only 1 string too low and how would I fix that? Thanks so much.

Croaky Keith
07-10-2017, 08:55 AM
You might be able to fix it up with a thin sliver under the string at the nut, worth trying. :)

Edit: You can also buy new nuts if the slots are too deep.

kypfer
07-10-2017, 11:34 AM
Does it only buzz on an open (unfretted) string? If so it's probably the slot in the nut needs a little shimming ... I use slivers of plastic food carton, yoghurt pot etc.

If it buzzes when the string is fretted, it may be that the saddle has been sanded a little too enthusiastically (and maybe asymmetricaly), again, a strip of plastic under the saddle may cure the problem, but this symptom could also be because of a high fret.

YMMV - good luck :)

ukantor
07-10-2017, 10:53 PM
It would be a good move to show your uke to an experienced player and ask their opinion. If there is a uke group/society/gathering that you can get to, you will find it an invaluable source of advice, help and encouragement.

robinboyd
07-11-2017, 12:19 AM
The 1 string? Is that the G string or the A string? If it's the G, is it a low G? Low G strings tend to buzz a bit. You could try changing to a different brand of strings to see if it helps.

Barrytone
07-11-2017, 12:23 AM
A quick check, a scrap of paper folded and placed under the string at the nut will raise the string. If it is a height problem, a drop of superglue mixed with baking powder in the slot will harden in minutes and can then be filed down to correct height.

Rllink
07-11-2017, 02:51 AM
This could be a long shot, but it doesn't cost any money and take very much time, just sight down the neck and make sure that it looks straight and there is no twist before you start messing with it.

Benjolele
07-21-2017, 05:42 AM
Where is it buzzing? Only the first few frets? Only as you get further up the neck? Throughout the whole length of the neck?

Booli
07-21-2017, 05:51 AM
No replies from the OP in 11 days, and this being their first ever post to the forum, I am not hopeful that this situation will be resolved, or if it is, we may not ever learn about it.

Maybe if the OP is reading this again, he/she can log in to the forum and offer an update? Thanks :)

CliveyG
11-03-2017, 12:42 PM
I thought I would post in this thread rather than start another similar thread. I have a uke which has a lower action than I would like. This one is 2mm, (measured with a good string action ruler) but interestingly, the action is lower than that on the a string?? Is it usual for the a string to be lower? Intonation is good at the nut end, but slightly flat after the 8th fret on the a string, not by much. The saddle is compensated.

CliveyG
11-03-2017, 12:48 PM
Just had another closer look and the a string slot at the nut looks lower than the others??

104143