PDA

View Full Version : Two builds - one student, one master



Pete Howlett
08-11-2018, 10:42 AM
Which is which?

111207

111208

mikeyb2
08-11-2018, 11:54 AM
the second is the student build.

Pete Howlett
08-11-2018, 12:12 PM
And you think this because?

mikeyb2
08-11-2018, 12:28 PM
And you think this because?
mainly because of the fretboard Pete, and the way the fret ends are finished. Also looks like the fretboard at the 16/17/18 frets is not as flat on the edge. This is not that bad, but I don't think you would allow one to go out that way.The other of course is faux bound(I can't think of the correct term).

Pete Howlett
08-11-2018, 05:17 PM
Nicely observed. My CNC is programmed to cut 'pocket frets'. So much less hassle than fingerboard binding.

Hms
08-14-2018, 12:08 AM
Same decision, for the fret ends!
h