End block radius

Timbuck · Dec 30, 2018

Just finished a batch of tail blocks ready for next year..And just for fun I made a video of how I shape the radius.
https://www.youtube.com/watch?v=glXd0FMaQ4w

Happy New Year

Jerome collector · Dec 30, 2018

Timbuck,
Just tried watching your youtube video and it comes up with "This video is unavailable".
Mike

Timbuck · Dec 30, 2018

Jerome collector said:
Timbuck,
Just tried watching your youtube video and it comes up with "This video is unavailable".
Mike

Try again I forgot to make it public

Jerome collector · Dec 30, 2018

All good now. Clever set up. Is there a reason for the blue painter's tape at the bottom of the holder for the end block?

Timbuck · Dec 30, 2018

Jerome collector said:
All good now. Clever set up. Is there a reason for the blue painter's tape at the bottom of the holder for the end block?

Yes the end of the jig that holds the workpiece is approximately.003" out of square on the vertical plain...and the single strip of tape corrects the error.

Steve-atl · Dec 30, 2018

Timbuck said:
Just finished a batch of tail blocks ready for next year..And just for fun I made a video of how I shape the radius.
https://www.youtube.com/watch?v=glXd0FMaQ4w

Happy New Year

Clever Thanks for posting it

End block radius

Timbuck

Well-known member

Jerome collector

Well-known member

Timbuck

Well-known member

Jerome collector

Well-known member

Timbuck

Well-known member

Steve-atl

Well-known member

Similar threads