Can you really get a good neck joint by the "flossing" technique?
I am putting together a Stewmac baritone kit.
There is a slight radius at the neck joint area, so the neck is high in the center. I have been working at this all morning and I am not sure am getting closer to a good neck joint. I think the problem is it's hard to hold the neck strait while pulling the sandpaper out. If the neck rocks then you are just acerbating the problem.
Any suggestions are appreciated
Thank you
I am putting together a Stewmac baritone kit.
There is a slight radius at the neck joint area, so the neck is high in the center. I have been working at this all morning and I am not sure am getting closer to a good neck joint. I think the problem is it's hard to hold the neck strait while pulling the sandpaper out. If the neck rocks then you are just acerbating the problem.
Any suggestions are appreciated
Thank you