Janko
Well-known member
My plans say that my sides (which are Walnut) should be about .07" or 1.778 mm thick. That is the typical thickness. What is that? Air? That's not even 1/32 "
Can't I go with 1/8th or is that still to thick? that is what they are now. Thank goodness my new sides are not 1/4 like my other ones (the one I broke) were. I would need a truck load of sand paper.
Now I know what all the huff about thickness sanders is about.
I would be grateful for any advice on the thickness. Are my plans correct? Can I cheat here a bit?
Can't I go with 1/8th or is that still to thick? that is what they are now. Thank goodness my new sides are not 1/4 like my other ones (the one I broke) were. I would need a truck load of sand paper.
Now I know what all the huff about thickness sanders is about.
I would be grateful for any advice on the thickness. Are my plans correct? Can I cheat here a bit?