OldePhart
Well-known member
I've been experimenting with some baritone strings. Tried a Pro-Arte JJ4405 high-tension classical guitar "A" string for the low D in a traditional baritone tuning. Loved it. Liked it a lot better than any of the baritone uke sets I've tried (less "squeak" than most of them) and it balanced very nicely with the fluorocarbon strings I'm using for the G, B, and E. Intonation at the 12th was dismal, which was very disappointing. Then, I noticed that in spite of being dismal at the 12th fret it was fine all the way to the tenth. I knew it wasn't the Mainland uke at fault because I've experimented a lot with strings on this uke and none of the others have been so wonky.
Looked at the brand new string closely and observed that there is a visibly thinner spot on the string, about 1/4" long and located between the 10th and 11th frets.
So...if you're trying new strings and something is strange, don't immediately assume that the strings are a bad choice for the uke!
John
Looked at the brand new string closely and observed that there is a visibly thinner spot on the string, about 1/4" long and located between the 10th and 11th frets.
So...if you're trying new strings and something is strange, don't immediately assume that the strings are a bad choice for the uke!
John