Hi Timbuck,
A question if I may:
I was asked to fit a new neck (electric guitar) to an existing body.
The width needed a bit of sanding, and thereafter I could slide the neck into the cut-out of the body.
The problem is : It sits snug in the body slot,
but it sits
too high and strings buzz.
The bridge height has been increased to max, but that did not help.
To make matters a bit more complicated the body of the cut out, curves (rather follows the curve of the body) on the back, which I should really try to follow to make it look right.
I therefore cannot make rectangular router cuts.
Have considered buying this which I saw on Rudy's webpage:
http://www.ebay.co.uk/itm/NEW-DRILL-PRESS-SAFETY-WOOD-PLANER-REPLACEMENT-WAGNER-SAFE-T-PLANER-1-2-SHANK-/110985453431?pt=LH_DefaultDomain_0&hash=item19d73f9f77
Have you got any advice for me?