The edge of installed fret wires

rreffner

Well-known member
Joined
Oct 10, 2008
Messages
688
Reaction score
438
Location
Tallahassee, Florida, USA, Earth
On my Kamaka the edges of the fret wires are noticeable when I slide my hand along the edge of the neck. Is there a way I can smooth them out? Small file? Thanks
 
I'm assuming your fret wire edges are the problem?

If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.
 
I'm assuming your fret wire edges are the problem?

If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.

But be careful when doing this so as not to mess up the finish.
 
Top Bottom