PDA

View Full Version : The edge of installed fret wires



rreffner
02-05-2009, 05:18 AM
On my Kamaka the edges of the fret wires are noticeable when I slide my hand along the edge of the neck. Is there a way I can smooth them out? Small file? Thanks

anomoly40
02-08-2009, 11:14 AM
I'm assuming your fret wire edges are the problem?

If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.

acabooe
02-09-2009, 03:54 PM
I'm assuming your fret wire edges are the problem?

If so take a small file and hold it at an angle and make sure to keep it flat against all frets, then finish it up with 150 and 200 grit sandpaper on a flat sanding block.

But be careful when doing this so as not to mess up the finish.