Results 1 to 3 of 3

Thread: Very Simple Uke to build

  1. #1
    Join Date
    Apr 2014
    Location
    Maine
    Posts
    38

    Default Very Simple Uke to build

    I just finished a project that might be a good starter project for first time builders due to it's simplicity. I built it as the ultimate travel uke for a month long island hopping adventure I am planning in April in the British Virgin Islands for snorkling and bonefishing. I wanted a Uke with a quick bolt on neck that could be taken down and the whole thing shoved into a small back pack. I made a sketch and used scrap, left over material and a salvaged neck from the reject pile and some old tuners off a beater Lanakai. This is what emerged:

    DSCF3292.jpgDSCF3293.jpgDSCF3294.jpg

    The instrument does not require any heat bending, it has a simple bolt on neck, (see here for a great how to: http://www.bluestemstrings.com/pageG...reeString.html )

    The sides and back are made of .125 baltic birch plywood so no thinning was required. There are no braces on the back. The top only has two braces in an A frame shape, tapered from 3/8 inch high under the bridge to nothing at the edge. The top was .125 Adirondack Spruce with a .015 relief route just inside the kerfing and then the 2" around the edge was sanded so that the edge was .080. With only a side sound port the whole top is active. 20.125 inch scale, 8 inch bout. The thing sounds very sweet, I am very surprised at the sound!!

  2. #2
    Join Date
    Mar 2009
    Location
    Hudson, MA
    Posts
    1,507

    Default

    Nice simple design. looks like lots of area for custom decals or artwork

  3. #3
    Join Date
    Jul 2010
    Posts
    332

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •