Parto
Active member
So in my haste I attached my back without removing a clamp holding the soundboard down in my mold
I managed to grind the head of the bolt off to remove the body from the mold but the wooden hold down is too big to fit through the sound hole.
Any ideas how to cut it down into pieces small enough to fit through the sound hole? I'm thinking maybe dremel with a router bit but any advise welcome. I won't be making this mistake again that's for sure.!!
I managed to grind the head of the bolt off to remove the body from the mold but the wooden hold down is too big to fit through the sound hole.
Any ideas how to cut it down into pieces small enough to fit through the sound hole? I'm thinking maybe dremel with a router bit but any advise welcome. I won't be making this mistake again that's for sure.!!
Last edited: