Hi - a friend brought me his ukulele to fix - there is no amplification. I pulled out the jack and circuit board and found the white lead broken off at the jack. I solder it back on to where it looked like it belonged and still no sound. The battery is fresh and the white connector is firmly attached to the circuit board. My question is where does the white wire goes? There is a red wire soldered to the short lead on the jack and the shield is soldered to the strain relief clamp. I soldered the white wire to the second longer lead on the jack. Does any one have a wiring schematic or picture. I am also wondering why 3 wires would connect to this type of jack if the guitar cable only wires to a hot and shield on the guitar plug.
Thanks,
Gary
Thanks,
Gary