Timbuck
Well-known member
Now’s the time to service the shop tools
Just stripped down the bandsaw this morning...replaced a couple of bearings in the blade guides and greased all the sliding parts...This afternoon I’ll start on the thickness sander and remove all the sawdust from inside the drum and fit a new sanding belt and re adjust the leveller settings....then a bit of maintenance on the lathe is needed...makes a change from making sawdust.
Just stripped down the bandsaw this morning...replaced a couple of bearings in the blade guides and greased all the sliding parts...This afternoon I’ll start on the thickness sander and remove all the sawdust from inside the drum and fit a new sanding belt and re adjust the leveller settings....then a bit of maintenance on the lathe is needed...makes a change from making sawdust.
Last edited: