dannyb
Well-known member
Aloha All
I am a novis builder. Upon finishing this (my 4th build) I ran in to some problems and sanded to the point of creating some divits and shadow lines. I am wondering about either leveling with ca or epoxy. These areas became more noticeable upon the start of lacquer. Any suggestions would be appreciated. Thanks
I am afraid of more sanding or scraping could cause a tear. One is noticable on the back. It is almost 1" in diameter. Other areas are on the side below the binding, as I was sanding a bleed under the wood binding. I 'm just wondering if it is not to late to try to level it with one of the above.
I am a novis builder. Upon finishing this (my 4th build) I ran in to some problems and sanded to the point of creating some divits and shadow lines. I am wondering about either leveling with ca or epoxy. These areas became more noticeable upon the start of lacquer. Any suggestions would be appreciated. Thanks
I am afraid of more sanding or scraping could cause a tear. One is noticable on the back. It is almost 1" in diameter. Other areas are on the side below the binding, as I was sanding a bleed under the wood binding. I 'm just wondering if it is not to late to try to level it with one of the above.
Last edited: