I posted a thread earlier about whether to get a truss rod or not in a baritone. So this is a followup question. I have tried a number of baritones that some folks in our Uke club have and they all have buzzing issues. Some buzzed all over the map, very extensive.
I've played high end ones, old ones and the general run of the mill moderate and cheap priced ones. All were familiar brands.
On the two higher end ones the strings seemed too soft and weren't wound strings so I wondered if they needed something a little higher tension or not.
Is it a general problem with Bari's due to scale length and DGBE tuning?
I'd really like to get one but I must say that I am a bit spooked by it all.
I've played high end ones, old ones and the general run of the mill moderate and cheap priced ones. All were familiar brands.
On the two higher end ones the strings seemed too soft and weren't wound strings so I wondered if they needed something a little higher tension or not.
Is it a general problem with Bari's due to scale length and DGBE tuning?
I'd really like to get one but I must say that I am a bit spooked by it all.