ukeanixi
Well-known member
Hi all,
I've been struggling with a couple of Lohanu LU-1 ukes:
1st one had the bridge cocked by 2mm, fixed it and it is playing very well now.
The amazon replacement came and I measured the nut to be 1.126 millimeter too far from the 1st fret. I have no idea how to fix that problem!
Both have about a 430mm scale length. The nut on the goofed up one is glued on firmly, am a little hesitant to remove it.
Any advice would be most appreciated.
measurements:
nut to 1st fret: 25.26mm [off by 1.126mm]
nut to the 12th fret: 216.5mm [off by at least 1.5mm]
I've been struggling with a couple of Lohanu LU-1 ukes:
1st one had the bridge cocked by 2mm, fixed it and it is playing very well now.
The amazon replacement came and I measured the nut to be 1.126 millimeter too far from the 1st fret. I have no idea how to fix that problem!
Both have about a 430mm scale length. The nut on the goofed up one is glued on firmly, am a little hesitant to remove it.
Any advice would be most appreciated.
measurements:
nut to 1st fret: 25.26mm [off by 1.126mm]
nut to the 12th fret: 216.5mm [off by at least 1.5mm]